does the magnet size on this sub make it weak?
two of these ma audio subs i would be sold but the magnet size kinda small plus i dont want mess up the subs..with my powerful amp….. and i want to slam hard so im not sure if this is my route …i want to be able max out the amp and not blow the subs is this a cool setup that wont break or is the magnet size too small for good bass
Features:
two Model: MA Audio MA150QS
Power Handling Capabilities:
900 Watts Power Handling
450 Watts RMS Power Handling
High Profile Treated Foam Surround
80 oz. Single Stacked Strontium Magnet Structure
Copper Wound Black Anodized Aluminum Voice Coils
Dual Laminated Cotton Spider
Rubber Sealant Gasket
Bumped T-Yoke
Platinum Plated Block Terminals
Black Powder Coated Stamped Steel Basket
Specifications:
Sensitivity: 90.35 dB
Impedance: 4 Ohm Single Voice Coil
running on a
RMS Power @ 14.4V:
750W x 1 @ 4 Ohm
1000W x 1 @ 2 Ohm
1500W x 1 @ 1 Ohm
RMS Power @ 17V
1000W x 1 @ 4 Ohm
1500W x 1 @ 2 Ohm
1800W x 1 @ 1 Ohm
Features:
Class D / X Monoblock Amplifier
2000W Digital Class X Competition Mono Block Amplifier
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Platinum Plated Block Terminals
Fully Unregulated Power Supply
Stainless Steel Finish Heat sink
Quiet Fan Cooling System
Remote Gain Control
Full Mosfet Circuitry
Fuse Rating: 40A x 4
Frequency Response: 10Hz – 350Hz
24dB Low Pass Filter: 50Hz – 350Hz
24dB Subsonic Filter: 15Hz – 50Hz
Variable 0 – 18dB Bass Boost Control at 45Hz
RCA Input Sensitivity: 0.2 – 8V
Low level Input Impedance: 22K Ohms
Damping Factor: 200 @ 4 Ohm
1 Ohm Mono Stable