is this a perfect match or do these subs suck?

two of these ma audio subs i would be sold but the magnet size kinda small plus i dont want mess up the subs..with my powerful amp….. and i want to slam hard so im not sure if this is my route …i want to be able max out the amp and not blow the subs

Features:

Model: MA Audio MA150QS

Power Handling Capabilities:

900 Watts Power Handling

450 Watts RMS Power Handling

High Profile Treated Foam Surround

80 oz. Single Stacked Strontium Magnet Structure

Copper Wound Black Anodized Aluminum Voice Coils

Dual Laminated Cotton Spider

Rubber Sealant Gasket

Bumped T-Yoke

Platinum Plated Block Terminals

Black Powder Coated Stamped Steel Basket

Specifications:

Sensitivity: 90.35 dB
Impedance: 4 Ohm Single Voice Coil

running on a

RMS Power @ 14.4V:

750W x 1 @ 4 Ohm
1000W x 1 @ 2 Ohm
1500W x 1 @ 1 Ohm
RMS Power @ 17V

1000W x 1 @ 4 Ohm
1500W x 1 @ 2 Ohm
1800W x 1 @ 1 Ohm
Features:

Class D / X Monoblock Amplifier
2000W Digital Class X Competition Mono Block Amplifier
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Platinum Plated Block Terminals
Fully Unregulated Power Supply
Stainless Steel Finish Heat sink
Quiet Fan Cooling System
Remote Gain Control
Full Mosfet Circuitry
Fuse Rating: 40A x 4
Frequency Response: 10Hz – 350Hz
24dB Low Pass Filter: 50Hz – 350Hz
24dB Subsonic Filter: 15Hz – 50Hz
Variable 0 – 18dB Bass Boost Control at 45Hz
RCA Input Sensitivity: 0.2 – 8V
Low level Input Impedance: 22K Ohms
Damping Factor: 200 @ 4 Ohm
1 Ohm Mono Stable

Leave a Reply