is this a perfect setup amp sub combo?

i want to be able to max out my amp not break the subs so at 4 ohms they are under powered at 1 ohm they are lil over powerd what do u think i cant afford to break subs

two of these bad boys
ma audio Dual 4 ohm
15" Competition Subwoofer
Power Handling:
Peak: 1200 watts
RMS: 600 watts
Heavy duty non-pressed paper cone woofer
Reinforced ribbed high foam surround
Ultra strong polypropylene dust cap
New patented black die-cast basket
Dual progressive dupont spiders
Platinum plated block terminals
Copper clad aluminum voice coil wire
Hi-temp kapton voice coil former
260oz. Double stacked strontium magnets
2-year Manufacturer’s warranty

on this beast

ma audio hdk2000
RMS Power @ 14.4V:

750W x 1 @ 4 Ohm
1000W x 1 @ 2 Ohm
1500W x 1 @ 1 Ohm
RMS Power @ 17V

1000W x 1 @ 4 Ohm
1500W x 1 @ 2 Ohm
1800W x 1 @ 1 Ohm

Class D / X Monoblock Amplifier
2000W Digital Class X Competition Mono Block Amplifier
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Platinum Plated Block Terminals
Fully Unregulated Power Supply
Stainless Steel Finish Heat sink
Quiet Fan Cooling System
Remote Gain Control
Full Mosfet Circuitry
Fuse Rating: 40A x 4
Frequency Response: 10Hz – 350Hz
24dB Low Pass Filter: 50Hz – 350Hz
24dB Subsonic Filter: 15Hz – 50Hz
Variable 0 – 18dB Bass Boost Control at 45Hz
RCA Input Sensitivity: 0.2 – 8V
Low level Input Impedance: 22K Ohms
Damping Factor: 200 @ 4 Ohm
1 Ohm Mono Stable

Comments are closed.