Low water pressure on well system?

Earlier this year I replaced my tank because the bladder had ruptured (it was probably 20-30 years old). While I was at it, I also replaced the switch just so that everything was new. The tank fills up fine and the switch is set properly for on and off settings (I’ve done it probably six times just to make sure that it is right). Anyway, ever since I did this, we have lower water pressure throughtout the house. There’s not enough pressure in the kitchen sink to make the dish soap lather up. There is copper throughout the house. The only place there is galvanized is from the top of the tank, going up about four feet where it connects with copper. Looking for some possible ideas to check out.

Comments are closed.